TL4100 Pillar LED Mounts

I downloaded the Geetech Rostock Delta LED strip clip by Quadsequence, as it looked like it would fit my Jaycar TL4100 (TL-4100) delta I bought a few weeks back, so i promptly printed it out. Unfortunately the pillar supports by Geetech are quite a lot larger, so I downloaded the STL and imported them into Tinkercad for editing. I filled the holes, made the arms shorter, made the overall width shallower to fit my ebay LED strip that I have laying around, and popped in some 7.8mm holes to make it a nice tight fit on the 8mm poles.

I tried affixing the LED strips to the PLA mounts, but the cheap adhesive kept coming off. I next tried some superglue, but managed to get my fingers stuck to everything :). So, the LED's eventually were stuck to the clips with 4 cable ties, between the gap of the LED's. I wired it underneath to the 12V input source of the duinotech board. It does get a bit "pulsy" when the heater bed is keeping the temp right, so I may filter the strips with a capaci