Thingiverse
Electronics
Go to Model
TM1638 LED&Key Case
66
Downloads
46
Likes
0
Makes
A case for the QiFei(?) TM1638 Led&Key module with integral buttons.
The pin-header on the module has to be desoldered or resoldered to the back, (at least it had to on my module...). I used M3 screws and M3x4mmx5mm embedded nuts to mount the module. The embedded nut can easily be set with a soldering iron.
The two halves can be (permanently) glued together or (reversably) fixed together with tape.
The pin-header on the module has to be desoldered or resoldered to the back, (at least it had to on my module...). I used M3 screws and M3x4mmx5mm embedded nuts to mount the module. The embedded nut can easily be set with a soldering iron.
The two halves can be (permanently) glued together or (reversably) fixed together with tape.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
