Cults3D
€ Paid
Art
Zum Modell
Toad face on window
3
Downloads
2
Likes
0
Makes
A cute 3D printable Toad figure from Super Mario, prepared as a ready-to-print model file. The model is approximately 14 cm tall when assembled.
The file is fully prepared for printing, and all required slicer settings are already included in the model file.
Print settings included:
Layer height: 0.2 mm
Infill density: 10%
Infill pattern: Gyroid
Supports: Enabled
Support type: Tree Hybrid
Support angle: 25°
Ignore small overhangs: Enabled
Top support Z distance: 0.16 mm
Top interface layers: 3
Top interface line spacing: 0
Maximum bridge length: 10 mm
Independent support layer height: Disabled
Branch angle: 60°
Branch diameter angle: 3°
Flushing volume: 1.3
For printing the body part, a pause is set at layer 170 so the filament can be manually changed from white to beige.
The file is fully prepared for printing, and all required slicer settings are already included in the model file.
Print settings included:
Layer height: 0.2 mm
Infill density: 10%
Infill pattern: Gyroid
Supports: Enabled
Support type: Tree Hybrid
Support angle: 25°
Ignore small overhangs: Enabled
Top support Z distance: 0.16 mm
Top interface layers: 3
Top interface line spacing: 0
Maximum bridge length: 10 mm
Independent support layer height: Disabled
Branch angle: 60°
Branch diameter angle: 3°
Flushing volume: 1.3
For printing the body part, a pause is set at layer 170 so the filament can be manually changed from white to beige.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
