Thingiverse

Toe Spike

by shaetano

204 Downloads

140 Likes

2 Makes

Mandalorian Toe Spikes similar to Boba Fett's ones worn in Empire Strikes Back.

I initially printed this at a 45 degree angle as printing with support is a must; but I wanted to keep the tip holes free from support material. In hindsight i suspect printing it at 90 degrees would be better as all the marks left from supports would be on the inside - boot side and not be visible out.

Source

Thingiverse

What you need to print this: Advanced Medium confidence

Why?

supports needed · very large print

Single piece Supports required May need scaling or splitting

Supports 2/3

Assembly 0/3

Settings 1/3

Bed size 3/3

Post-process 0/3

Printer

FDM / FFF

File format

STL

Material

Min. bed size

300 mm (Extra large)

Software

Cura, PrusaSlicer, or similar

Frequently Asked Questions

Which 3D printer is suitable for Toe Spike?

Any FDM printer should handle Toe Spike just fine. It's been printed on machines like Bambu Lab X1C, Prusa MK4, Creality K1 Max, Anycubic Kobra Max. A minimum build volume of 300 mm is recommended.

Does Toe Spike need supports when printing?

Yes, Toe Spike will probably need supports for the overhangs. Tree supports work well here and are easier to remove than regular ones.

What file format is Toe Spike available in?

Toe Spike is available in STL format. These files can be opened and sliced using free software such as Cura, PrusaSlicer, Bambu Studio, or OrcaSlicer for FDM printing, or ChiTuBox and Lychee Slicer for resin printing. The download is provided through Thingiverse.

Is Toe Spike free to download?

Yes, Toe Spike is available as a free download through Thingiverse. Always check the license on the original platform to understand commercial use, remixing, and attribution requirements.

No ratings yet

No comments yet – be the first!

Similar Models

6 Suggestions

Toe Spike

Similar Models

Add to Collection