Thingiverse
ToM filament guide
von pauldebra
8
Downloads
20
Likes
2
Makes
Just created this filament guide which mounts on top of the ToM, using the screws that hold the back z-rods. (The screws are long enough.)
This is especially useful when you have a filament spool located behind the bot.
This is especially useful when you have a filament spool located behind the bot.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!