Tomahawk 60 Flywheel Cage

This is a 3d printed flywheel cage for the Adventure Force Tomahawk 60, allowing for higher crush and better performance. The numbers denote the crush for each cage.
Installation will require one cut to part of the shell, as pictured, and the replacement cage will drop into place. You no longer need some shell cutting on the side of the shell in order for the motors to fit, however you may need and a bit of sanding in order for the flywheels to move smoothly.

The cage does screw directly on to the shell. However, do note that the screws from the cover of the internals are not necessary.

This cage is compatible with any standard sized flywheel and any hobby-grade 130 or 180 sized motor. Tighter crushes may require motors with higher torque.

This print does require supports.