Thingiverse
Tombstone Bat
by Blairski
1.2k
Downloads
966
Likes
4
Makes
A simple hand crank sculpture / toy.
Printed with Ivory Z-Ultrat on a Zortrax M200. The "axles" used in hinges are raw 1.75mm filament right off the spool. After the main parts are printed and glued together, a 5/64" drill bit was used to clear and standardize all of the holes at hinge points (and in end caps).
The weight box was filled with lead shot to give it a little more weight for support (fishing weights, etc. could work just as well).
NOTE: You will need to print 2 of: TombstoneBat__linkageArm_1.stl
Printed with Ivory Z-Ultrat on a Zortrax M200. The "axles" used in hinges are raw 1.75mm filament right off the spool. After the main parts are printed and glued together, a 5/64" drill bit was used to clear and standardize all of the holes at hinge points (and in end caps).
The weight box was filled with lead shot to give it a little more weight for support (fishing weights, etc. could work just as well).
NOTE: You will need to print 2 of: TombstoneBat__linkageArm_1.stl
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!