Tommy Blinder

Parts for pinball Tommy Blinder made by DataEast

The parts for the Tommy blinder should be printed in best quality upside down. Becaus of this two small parts have to be added. They should be printed on one side with a brim. One can be pressedd in (but not too hard), the other has to be glued to the main part. Bevor glueing sand these areas.
There are models with two diameters for a 6mm axis and a 6,35mm (the original) axis. Because on my Ender the holes became smaller i added .2 to the holes. You should test this.

Added the Servo-Arm for the Blinder.
Because servos with a metall gear are recommanded, i combined a metal servo arm with a printed adapter. Check whether your servo has 23, 24, or 25 teeth spline shaft. The lenght of the sleeve (not included) and the screw have to be adapted.

The models were created with PTC Creo Elements Direct Modeling Express 6.0.
This programm is free, but can only read native pkg2, step, stl and write only pkg2, stl and pictures.