Toniebox stand

This is a stand for a Toniebox with two shelves which can hold Tonies on both the top and the underside. It requires two mild steel plates, 100mm square and 2mm thick, which are easy to find on Ebay, for example. The steel plates are slotted in to the two shelves from the back, before the shelves are slotted in to the back panels. I wedged some cardboard in the slots after the steel plates, to stop them sliding about. The two halves of the back panel are then joined with the small pegs, before being connected to the base. Note there are two holes in the joining edge of the two halves, that may be hard to see as they have support material in them. The dovetails connecting the shelves were quite a tight fit for me, so some light filing or sanding may be required. The Toniebox charger can be inserted from underneath and then seated in the base, with the wire passing out the slot to the rear. I printed using PLA for supports, which worked well enough, but they were a little tricky to remov