Thingiverse
Tonor microphone stand
von FlatBadger
8
Downloads
8
Likes
0
Makes
A 3d printed stand to replace the tripod on a Tonor mic.
The supplied tripod sits too high for my needs, so I designed this stand. It should fit anything that takes a 5/8" threaded mount.
I printed it on a Prusa Mk2.5s with a layer height of 0.2 but with adaptive layering enabled to get the finer detail on the thread,
The supplied tripod sits too high for my needs, so I designed this stand. It should fit anything that takes a 5/8" threaded mount.
I printed it on a Prusa Mk2.5s with a layer height of 0.2 but with adaptive layering enabled to get the finer detail on the thread,
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!