Thingiverse
Toob Adapter
von j3f
0
Downloads
3
Likes
0
Makes
A 19mm-10mm tube/pipe adapter
I needed a tube adapter to be able to use standard 20mm PVC plumbing, overflow, pipe on a filament holder, this is also the size of pipe shipped with the standard filament holder for the GEEETech i3 printers.
I printed it in PLA, dropped a bit of super glue on the end then inserted into the pipe and its been holding up a 1 KG spool for a couple of days now.
I used this filament holder from Ali55; http://www.thingiverse.com/ali55
Thing: http://www.thingiverse.com/thing:1319713
I needed a tube adapter to be able to use standard 20mm PVC plumbing, overflow, pipe on a filament holder, this is also the size of pipe shipped with the standard filament holder for the GEEETech i3 printers.
I printed it in PLA, dropped a bit of super glue on the end then inserted into the pipe and its been holding up a 1 KG spool for a couple of days now.
I used this filament holder from Ali55; http://www.thingiverse.com/ali55
Thing: http://www.thingiverse.com/thing:1319713
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
