Thingiverse
Tool Holder
von FullerDesigns
120
Downloads
52
Likes
0
Makes
This is a basic tool holder i designed and cut out with my shapeoko xxl.
Files are a dxf. of the holder and also the carbide create file.
Material i used: I had 3 sheets of pine measuring .75" x 11.25" x 22.00". glued them together with titebond III and made the overall thickness to be 2.25 thick.
Bits i used: .250 flat endmill that came with my shapeoko and a .125 flat endmill.
Depths of cuts: the portion i used to hold the washers, bolts, tools, bit cases and slots for clamps were 1.25 deep. the holes for the 1/4" shank bits were .625 deep and the holes for the 1/8" shank bits were .500 deep.
Time of cut on my shapeoko took about 3hr and 15min.
DO NOT RELY ON MY SPEEDS AND FEEDS AND TOOL PATHS. new to the cnc world lol just a warning.
Files are a dxf. of the holder and also the carbide create file.
Material i used: I had 3 sheets of pine measuring .75" x 11.25" x 22.00". glued them together with titebond III and made the overall thickness to be 2.25 thick.
Bits i used: .250 flat endmill that came with my shapeoko and a .125 flat endmill.
Depths of cuts: the portion i used to hold the washers, bolts, tools, bit cases and slots for clamps were 1.25 deep. the holes for the 1/4" shank bits were .625 deep and the holes for the 1/8" shank bits were .500 deep.
Time of cut on my shapeoko took about 3hr and 15min.
DO NOT RELY ON MY SPEEDS AND FEEDS AND TOOL PATHS. new to the cnc world lol just a warning.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
