Thingiverse
Tool Holder
3
Downloads
1
Likes
0
Makes
BEFORE PRINTING:
-Be sure that this model corresponds to your needs.
-Be sure to have the right pegboard that goes with the holder.
-Be aware that the installation of this holder will require some tools and planification.
-Print the hex sockets of the part face down on the 3D printer.
-Use 1mm thick manually placed supports for the pegboard clips
-No rafts needed
-Remove supports
-Choose the final location of your tool holder since it would be hard to remove if a change is made
The hex tools on the tool holder should will be a press-fit at first. With wear, the tools will fit more easily. Also, the tool holder once installed on the pegboard will be hard too remove. Its made to resist and stick as hard as it can to the pegboard and not made to change frequently of place.
-Be sure that this model corresponds to your needs.
-Be sure to have the right pegboard that goes with the holder.
-Be aware that the installation of this holder will require some tools and planification.
-Print the hex sockets of the part face down on the 3D printer.
-Use 1mm thick manually placed supports for the pegboard clips
-No rafts needed
-Remove supports
-Choose the final location of your tool holder since it would be hard to remove if a change is made
The hex tools on the tool holder should will be a press-fit at first. With wear, the tools will fit more easily. Also, the tool holder once installed on the pegboard will be hard too remove. Its made to resist and stick as hard as it can to the pegboard and not made to change frequently of place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
