tool hook

Just a hook for wall mounted tool storage.

Sketchup 2017 files included for customising.

Mounting hole is 2.4mm, drill out the hole if larger mounting screws are required.
In some cases, you may feel the mount is too close to the wall to enable good grip on the tool, sketchup files included for modification if so desired.

These are printed "end on". See picture with the green hooks. This is the orientation in which they are printed.
The stretch version, (Tool bracket3) is 100mm in length.
A Brim is recommended for printing this to give some support as it is higher from the print bed. (I had one failing, so added brim in cura, printed and came out ok, or some good adhesive on the bed, or combination of both).

EDIT 29/10/19
A 3 hook bracket was produced.
change print orientation if required from that shown in the picture.