Tool Tidy

V2 Alterations:

1)Have realised I can improve this slightly, so have posted "V2".Basically, the original works fine but I'm finding it just a little fiddly to slot the scraper into it's slot. I have therefore added a slightly higher back wall that will help guide the scraper in without needing to be so careful.

2) Have made the slot for the callipers a bit bigger as it fit one of my callipers but the other was too big as it had a small bracket holding the slider in place. If you hold the callipers as if reading them, you might have a small bracket close to the end of the slidey bit (far right). The original allows for this to be 4 mm thick, V2 7mm (photo added to show the bit I mean).

********************************************************

Another tool tidy. I made this for all the tools I use for printing, spare parts etc but also as a learning exercise for myself in Fusion 360. Very nice clean print, but takes a while.

All the tool spaces are pretty generic. Th