Toolbox

Just a simple organizer for ratchets, extensions, and screw drivers, printed a few dozen of these out for myself so far. In order to use these first measure the diameter of your tools, and print one for each side. If your tool is say a 3/8 extension, I found that I would need 2 20mm Vs. My 3/8 ratchets instead needed both a 20mm V and a 25mm (wide) V, one for the head and one for the handle.If you are using a 20mm V and a 30mm V, you will want to print 2 5mm spacers, to keep the part centered. I also have included a 20mm and 30mm V which are 2.5mm wider on each side, as a 2.5mm spacer was impossibleFinally; the files are fairly close tolerances and I believe I could only get them to print on the .16mm default setting for my A1, or else they were too tight and would not mesh.