Thingiverse
ToolPro Small Case Tray
by lozza6
1
Downloads
1
Likes
0
Makes
I designed a tray to be used in the ToolPro case so that I could lift out the top layer and access the 2nd layer of foam padding easily.
I used this for my Mavic Air and Insta360 accessories and it worked a treat!
Sadly my Ender 3 Pro was just too small to print it all in one go so I have also included a halved model where you'll have to print 2 and the melt them together with a soldering iron.
I gave it a slight overlap and spot welded parts together before then running it down the middle to fuse it together.
Printing:
I printed 100% infill with retraction disabled. Stringing will need to be cleaned up at the end.
I picked up my ToolPro case from Supercheap Auto(Australia) when it was on special for $10
https://www.supercheapauto.com.au/p/toolpro-toolpro-safe-case-small-black-260-x-245-x-175mm/326042.html
I used this for my Mavic Air and Insta360 accessories and it worked a treat!
Sadly my Ender 3 Pro was just too small to print it all in one go so I have also included a halved model where you'll have to print 2 and the melt them together with a soldering iron.
I gave it a slight overlap and spot welded parts together before then running it down the middle to fuse it together.
Printing:
I printed 100% infill with retraction disabled. Stringing will need to be cleaned up at the end.
I picked up my ToolPro case from Supercheap Auto(Australia) when it was on special for $10
https://www.supercheapauto.com.au/p/toolpro-toolpro-safe-case-small-black-260-x-245-x-175mm/326042.html
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!