Thingiverse
Tooth Brush Holder
door Groenkop
7
Downloads
11
Likes
0
Makes
REV 2
Added some support and dividers to the model. Was getting some idea improvements.
Simple & Practical Toothbrush Holder – Easy-to-print design that keeps your toothbrush upright and your sink clutter-free.
Support-Free Print – Designed for hassle-free printing with minimal filament use.
Hygienic Storage Solution – Keeps brushes elevated for faster drying and better organization.
Recommended Print Settings:
Layer height: 0.2 mm (or finer for smooth finish)
Infill: 15–20%. Gyroid
Supports: Not required
Material: PLA is what i used
Wall count: 2–3 for durability
Share your makes if you decide to make one
Added some support and dividers to the model. Was getting some idea improvements.
Simple & Practical Toothbrush Holder – Easy-to-print design that keeps your toothbrush upright and your sink clutter-free.
Support-Free Print – Designed for hassle-free printing with minimal filament use.
Hygienic Storage Solution – Keeps brushes elevated for faster drying and better organization.
Recommended Print Settings:
Layer height: 0.2 mm (or finer for smooth finish)
Infill: 15–20%. Gyroid
Supports: Not required
Material: PLA is what i used
Wall count: 2–3 for durability
Share your makes if you decide to make one
Groenkop publiceert ook op
18 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
