Toothbrush Holder (for two) - Quick Print

I broke the cup that used to hold the toothbrushes, so I grabbed pencil and paper again and whipped up a replacement. So far, the wife hasn't accused me of breaking stuff just so that I can make it myself, but I think that's coming soon. This is a straightforward design. Double sided tape goes on the larger surface area of the small rectangle, then you simply slide the holder onto it. 45 min. to print5 min. to assemble IMPORTANT:Note the orientation of the models. This is to minimize the use of support.Be careful when removing the small bit of support from the bottom of the main model.To put the faceplate (cover) on, insert the side pin into one of the holes, then gently widen the front as you slide the other pin in. Lastly, I designed this to not open all the way. My wife kept leaving it open, so I changed the design to have gravity close it. To remove a brush, you just grab the handle and pull it towards you, then it closes on its own. Depending on the print layer height, fil