Toothbrush Holder - Hexagonal

No supports or glue needed! Prints in 5 main pieces (Top plate, bottom plate, and 3 posts) held together with 6 printed clips.

Assembly
----
* Press 3 clips into the base plate. Press until they click into place. You may have to press pretty hard.
* Press the three posts into the base plate clips. Again, press until they click. Posts are symmetric, it doesn't matter which side is clipped into the base plate.
* Press 3 more clips into the tops of the 3 posts. Press until they click.
* Finally, press the top plate into the three clips on the three posts. Again, press until they click.