Thingiverse
Toothbrush holder
por MKapnoudhis
1
Descargas
2
Likes
0
Makes
Some toothbrushes are fat and some are thin. This toothbrush holder is designed to accommodate all different types of toothbrushes and toothpaste tubes.
It can either be printed in a couple of different parts that can be glued or accetoned together (when printing ABS), or as only two parts that just press fit together.
The base goes in deeper into the tube to lift the base up a few millimeters from the surface it is placed on to allow water to run out and just wiped up every now and then.
Pay attention to how the bottom plate is placed on the print bed since it is beveled on the on side to allow for water to run to the middle and down to hole. If the water is allowed to collect it stinks after a while.
It can either be printed in a couple of different parts that can be glued or accetoned together (when printing ABS), or as only two parts that just press fit together.
The base goes in deeper into the tube to lift the base up a few millimeters from the surface it is placed on to allow water to run out and just wiped up every now and then.
Pay attention to how the bottom plate is placed on the print bed since it is beveled on the on side to allow for water to run to the middle and down to hole. If the water is allowed to collect it stinks after a while.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
