Thingiverse
Toothbrush holder wallmount
von 3DAx
5
Downloads
6
Likes
0
Makes
usefull wallmount to park your toothbrush.
to mount i used a double sided tape an it holds fine.
the holes for the toothbrushes are 35mm wide.
I printed this part on my CR10 with 0,3mm layer height and with support.
I hope you will find this thing helpful :)
Check out my Designs on Pinshape.com
http://bit.ly/Pinshape
to mount i used a double sided tape an it holds fine.
the holes for the toothbrushes are 35mm wide.
I printed this part on my CR10 with 0,3mm layer height and with support.
I hope you will find this thing helpful :)
Check out my Designs on Pinshape.com
http://bit.ly/Pinshape
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
