Thingiverse
Toothpaste Dispenser
por DanielMitchell
1.8k
Descargas
2.1k
Likes
9
Makes
#Awesome Toothpaste Dispenser
This unique design/creation allows you to distribute toothpaste directly onto your toothbrush. It also acts as an additional toothbrush stand or holder.
• The toothpaste extruder can be locked in place to prevent tubes from rolling out.
• Additional toothbrush holders can be printed depending on the amount of users.
• The toothpaste extruder/roller can also be used separately as a portable version.
The design was printed and tested using Ultimaker Cura 3.6.0, with the following settings (PLA):
Base & Toothbrush Holders
layer height: 0.24
Infill: 35%
Supports: No
Stand
layer height: 0.20
Infill: 35%
Supports: Yes
Extruder & Extruder Shaft
layer height: 0.20
Infill: 35%
Supports: No
• The total print time can be expected at around 11 hours.
Don't forget to comment or like.
Thanks.
This unique design/creation allows you to distribute toothpaste directly onto your toothbrush. It also acts as an additional toothbrush stand or holder.
• The toothpaste extruder can be locked in place to prevent tubes from rolling out.
• Additional toothbrush holders can be printed depending on the amount of users.
• The toothpaste extruder/roller can also be used separately as a portable version.
The design was printed and tested using Ultimaker Cura 3.6.0, with the following settings (PLA):
Base & Toothbrush Holders
layer height: 0.24
Infill: 35%
Supports: No
Stand
layer height: 0.20
Infill: 35%
Supports: Yes
Extruder & Extruder Shaft
layer height: 0.20
Infill: 35%
Supports: No
• The total print time can be expected at around 11 hours.
Don't forget to comment or like.
Thanks.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
