TOOTHPASTE HOLDER SPRING & EXTRUDER

That's my idea of toothpaste holder extruder. If want one you need to print the five pieces.

You can fixed it to the wall by screw and nylon bushing or using extra strong VHB ribbon from 3M or another you want.

Assembly:

First step - To assemble it you must fasten the "Toothpaste_Holder_square_Grooved" piece in the rectangular recess on the left side of the extruder through a super glue.

Second step - Place the M-shaped spring into the rectangular recess inside the right-hand cylinder of the extruder.

Third step - insert from right to left the shaft through the central bore of the spring and the extruder.

Fourth step - using super glue attach the "Toothpaste_Holder_Lock" at the free end of the left side axle. Be careful not to stick the lock in the slotted rectangle. To pevent this from happening, press de handle at the right end of the shaft to move the lock away from the other part until the glue dries.

To use:
Put the bottom of toothpaste tube through lower op