Toothpaste Wringer (Looser fit)

If you can't print this, please consider ordering it through my 3DHub at:
http://3dhubs.com/service/8Bit

The original design, the clip and pin were so tight I had to shave some off to be able to get them on and off each other without breaking them. Now they slide on with resistance, but I don't need pliers. I shaved .2mm off the outter sides of the pin where it meets the clip.
_________________________________________________
If you are going to ORDER the part from someone, please consider ordering it from my 3D hub at the link below:
https://www.3dhubs.com/service/163675

Find all my designs with #8BitFPV