Thingiverse
Toothpick Dispenser
door Cbrockett
13
Downloads
13
Likes
0
Makes
I needed a better container for toothpicks that I use to mix paint and glue. This is designed to fit a specific space in a metal rack, but I thought I would upload in case it's helpful to others.
There are press fit cutouts in the back for 2 1/4" x 1/8" magnets that hold it in place.
You will also need to add some weight to the tab on the bottom of the toggle barrel so that it resets. I used a couple of steel nuts glued on.
The main body uses minimal supports when printed with the front face downward. All other parts print without support.
When assembling, the slot in the barrel should be facing up and the tab should be facing the back.
The knobs are a tight fit in the barrel so they may be difficult to remove once pushed into place.
There are press fit cutouts in the back for 2 1/4" x 1/8" magnets that hold it in place.
You will also need to add some weight to the tab on the bottom of the toggle barrel so that it resets. I used a couple of steel nuts glued on.
The main body uses minimal supports when printed with the front face downward. All other parts print without support.
When assembling, the slot in the barrel should be facing up and the tab should be facing the back.
The knobs are a tight fit in the barrel so they may be difficult to remove once pushed into place.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
