Thingiverse
Toothpick shaker-dispenser
by Dragoyle
16
Downloads
12
Likes
0
Makes
Simple toothpick shaker with a small dispense hole at one end.
Two-piece design snaps together with no Mod.
Sliced on Cura flat sides down and printed in less than 2 hours.
PLA @ 200C with skirt adhesion.
Just clean flash from the build plate and start using. No support required
After snapping together, it can be reopened repeatedly by carefully prying at the parting line with a thin-bladed knife.
Two-piece design snaps together with no Mod.
Sliced on Cura flat sides down and printed in less than 2 hours.
PLA @ 200C with skirt adhesion.
Just clean flash from the build plate and start using. No support required
After snapping together, it can be reopened repeatedly by carefully prying at the parting line with a thin-bladed knife.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!