Toothy McKnuckles

A comfy Knuckle, with a toothy, but not gaudy spiked main striking surface and tapered secondary striking surfaces for backhand (think cross draw from an inner jacket pocket) and hammer fist strikes.

The finger stalls in this are 20mm Wide by 25mm Tall, this will print flat without supports and coming in at 15mm thick is nice and chunky, if you need to scale it up or down I would recommend changing the X and Y scaling by the same percentages, and leaving the Z scale at 100 percent.

Lots of people insist on printing at 100 percent infill for knuckles, but for PLA+, 5 walls, 5 top layers, and 5 bottom layers with 10 percent gyroid infill should do fine, these aren't supposed to break cinder blocks, punch bags with ill intent are softer than PLA+

This file is for a set of Printable knuckles intended for Prop use, be sure to use flexible filament or print as few perimeters and as little infill as possible while still maintaining the integrity of the print, so it is easy to prove they a