Thingiverse
Top filament guide
von Earthbound_
12
Downloads
10
Likes
2
Makes
A guide designed for my Diggro Alpha-3.
The existing guide designs I found for printers of this frame design were all intended to mount to the front slot on the top bar. My frame has no slot there.
This guide mounts to the outer slot of the left upright. As designed, it may reduce your maximum Z height.
A key aspect of this design is the cone in the eye of the guide. It is there to insure the PTFE tube on the extruder inlet will not snag at high Z
The existing guide designs I found for printers of this frame design were all intended to mount to the front slot on the top bar. My frame has no slot there.
This guide mounts to the outer slot of the left upright. As designed, it may reduce your maximum Z height.
A key aspect of this design is the cone in the eye of the guide. It is there to insure the PTFE tube on the extruder inlet will not snag at high Z
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
