Thingiverse
Top-Mount Hook
by OleMurpho
0
Downloads
0
Likes
0
Makes
Info
♦ Screw Hole Diameter: 5mm
♦ Hook Passthrough Width: 20mm
♦ STEP Included for improvisation.
♦ Alternative included because the original sucks to mount.
Tips
♦ 60% Cubic Infill is rigid while economic.
♦ Print original model flat, brim recommended. (0.16 separation gap and the skirt peels right off.)
♦ Print alternative model horizontal on side with plate supports. (0.32 Z distance breaks nicely on supports.)
♦ Pre-drill holes, tighten with wrench.
Haiku
This is a nice hook.
It will hold your stuff aloft.
Don't bump your head though.
♦ Screw Hole Diameter: 5mm
♦ Hook Passthrough Width: 20mm
♦ STEP Included for improvisation.
♦ Alternative included because the original sucks to mount.
Tips
♦ 60% Cubic Infill is rigid while economic.
♦ Print original model flat, brim recommended. (0.16 separation gap and the skirt peels right off.)
♦ Print alternative model horizontal on side with plate supports. (0.32 Z distance breaks nicely on supports.)
♦ Pre-drill holes, tighten with wrench.
Haiku
This is a nice hook.
It will hold your stuff aloft.
Don't bump your head though.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
