Thingiverse
Toploader deck box
von grathxvi
15
Downloads
9
Likes
0
Makes
Magic: The Gathering deckbox, designed to hold an EDH deck with the commander in a top loader used to close the box.
Deckbox.stl and DeckboxLid.stl are scaled for double-sleeved cards, whereas Deckbox60.stl and DeckboxLid60.stl are scaled for single-sleeved.
In my experience, the intended mechanical closure for the lid (slide it on with the rails, then lock it into the pegs) didn't work that well. I ended up printing the box in ABS and then welded the top on with acetone; if you go that route, you may wish to edit the source .scad files to remove the rails and just use the pegs for alignment.
Deckbox.stl and DeckboxLid.stl are scaled for double-sleeved cards, whereas Deckbox60.stl and DeckboxLid60.stl are scaled for single-sleeved.
In my experience, the intended mechanical closure for the lid (slide it on with the rails, then lock it into the pegs) didn't work that well. I ended up printing the box in ABS and then welded the top on with acetone; if you go that route, you may wish to edit the source .scad files to remove the rails and just use the pegs for alignment.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
