Topwater frog

I didn't make any legs but you can use the legs from the older lure or create one yourself from a piece of wood of some sort. You may have to scale it up or down, IDK. I like to add a spinning blade to the end of the legs. You can also add smaller treble hooks with bucktail or feather in place of the blades.

When you assemble the legs to the body, I recommend keeping the legs spread and not close to each other. They usually end up tangled and a big mess.

1 piece version and a two pieces version. Add a pause so you can add BB if you're going to print the 1 piece version.
NO SUPPORT needed if you're printing the two halves.

Lure Volume is 48.27 g/cm3. Currently printing the 1 piece (belly on build plate) with support at 5walls and 5%infill which give me a total weight of 22.85g. Paused at layer 86 right before the bridge. Time is 41min. My filament is density is 1.177g/cm3 (YMMV)


Youtube shorts: https://youtube.com/shorts/iewg2qn7JGQ

https://youtu.be/TggWrpgPn6U