Thingiverse
TorchStrapBracket
von Mr_Devine
0
Downloads
0
Likes
0
Makes
I made this bracket which is used for an over the shoulder torch strap.
ID 38mm,
Initial Print .15mm layer height with support, Infill 10%.
Going to Try TPU to make it flexible
https://www.tinkercad.com/things/3UoWT7AYaVY
ID 38mm,
Initial Print .15mm layer height with support, Infill 10%.
Going to Try TPU to make it flexible
https://www.tinkercad.com/things/3UoWT7AYaVY
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!