Thingiverse
Torghast lamp
di dextraise
0
Download
0
Likes
0
Makes
I made this lamp in stream (twitch.tv/gentilrex :D ).
I didn't print it yet.
There should be supports on the top part, but the base shouldn't need any.
As I see it, you don't need much infill (not more than 5-10%) as there shouldn't be too much pressure applied to it.
You will need to put LEDs on the bottom part, all around it.
I didn't print it yet.
There should be supports on the top part, but the base shouldn't need any.
As I see it, you don't need much infill (not more than 5-10%) as there shouldn't be too much pressure applied to it.
You will need to put LEDs on the bottom part, all around it.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!