Thingiverse
Torque wrench
von rrrlasse
4
Downloads
1
Likes
0
Makes
If printed in PETG at 100% infill it should be able to torque between 0 - 3 Nm.
PLA doesn't bend as well and gets brittle over time, so I don't think it's suitable.
When printed, break off the tiny split on the bottom that connects the tip of the handle with the scale. It's there to prevent the scale from warping during print.
Print with no supports.
Fusion 360 source included.
PLA doesn't bend as well and gets brittle over time, so I don't think it's suitable.
When printed, break off the tiny split on the bottom that connects the tip of the handle with the scale. It's there to prevent the scale from warping during print.
Print with no supports.
Fusion 360 source included.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!