Slicer Discord
Torvol Quad Pitstop Bungee Hook – 3D-printbaar model van Thingiverse Thingiverse

Torvol Quad Pitstop Bungee Hook

door fitzsicn
8 Downloads
10 Likes
1 Makes
Model downloaden
I received the Torvol Quad Pitstop backpack for Christmas and I wanted to be able to add a quad to the back of it if needed. I didn't want to do any permanent mods, and I wanted to keep it simple so I just came up with a hook that goes over the existing buckle straps. The hook is designed for 5mm elastic cord (Purchased from WalMart in the automotive section - "Hyper Tough 10-Pack Canopy Tie Set"). Two copies of the hook are needed. Sliding the buckle through them to get them on the side straps is a tight fit, but it will work with a bit of stretching. When I'm not using the elastic strap I just store it in the backpack but leave the hooks on the buckle.
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie