Thingiverse
Touch keypad for fischertechnik
par juh
6
Téléchargements
3
Likes
0
Makes
Uses a cheap ripoff of the retired [SparkFun Capacitive Touch Keypad](https://www.sparkfun.com/products/retired/12017) from [aliexpress](https://de.aliexpress.com/wholesale?SearchText=MPR121+keypad). There's different versions, I assume they all use the same overall layout, though.
Warning: My board came with faulty soldering of the MPR121 chip. It showed up under the address 0x7B but wouldn't work otherwise. It seems some pins were either short-circuited to other pins or not connected at all. With a lof of flux and resoldering I got it to work as expected with the 0x7A address. If some of the keys don't work, most probably it's due to too much, not too little, solder.
For printing the transparent part: The standard diagonal criss-crossing pattern results in lots of tiny air bubbles which will cloud the view. So the most important trick, not mentioned in most transparent printing guides, is making Cura print only parallel lines by putting "[90,270]" into the *Top/Bottom Line Dire
Warning: My board came with faulty soldering of the MPR121 chip. It showed up under the address 0x7B but wouldn't work otherwise. It seems some pins were either short-circuited to other pins or not connected at all. With a lof of flux and resoldering I got it to work as expected with the 0x7A address. If some of the keys don't work, most probably it's due to too much, not too little, solder.
For printing the transparent part: The standard diagonal criss-crossing pattern results in lots of tiny air bubbles which will cloud the view. So the most important trick, not mentioned in most transparent printing guides, is making Cura print only parallel lines by putting "[90,270]" into the *Top/Bottom Line Dire
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !