Thingiverse
Towel rack
por BYOS3D
1
Descargas
13
Likes
0
Makes
This is a towel holder, originally designed for bathroom use, but feel free to install it wherever you prefer.
The project includes two versions, both made of two separate parts:
Two-part model (screwed): assembled using M3 x 20 mm screws.
Two-part model (glued): assembled using instant glue (super glue).
Both versions are fixed to the wall using high-quality double-sided tape, allowing for easy installation without drilling holes in the wall.
Printing settings
Material: ABS
Walls: 3 perimeters
Top layers: 4 layers
Bottom layers (initial layers): 4 layers
No supports required for printing either model
In the attached photos, you can see the holder installed in my bathroom, already in use and firmly fixed.
I hope this project is useful to you.
Feel free to post photos of your prints and share any improvements or adaptations.
Thank you! 🖨️👊
The project includes two versions, both made of two separate parts:
Two-part model (screwed): assembled using M3 x 20 mm screws.
Two-part model (glued): assembled using instant glue (super glue).
Both versions are fixed to the wall using high-quality double-sided tape, allowing for easy installation without drilling holes in the wall.
Printing settings
Material: ABS
Walls: 3 perimeters
Top layers: 4 layers
Bottom layers (initial layers): 4 layers
No supports required for printing either model
In the attached photos, you can see the holder installed in my bathroom, already in use and firmly fixed.
I hope this project is useful to you.
Feel free to post photos of your prints and share any improvements or adaptations.
Thank you! 🖨️👊
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
