Towel Radiator Bracket

After my bathroom fitter tiled my bathroom, the pipes that came through the wall were no longer long enough for the brackets that came with the radiator. So I designed some shorter ones. They're adjustable from about 45mm to about 60 mm.

You will also need (per bracket):
- 1x M6 countersunk bolt + hex nut.
- 1x short M5 bolt, I use hex head as it's easier to use an Allen key through the radiator than it is a screwdriver behind the radiator.
- 1x flat M5 nut, slot nuts for extrusion work perfectly.
- Hardware to fit to your wall.

###Printing Instructions
The only piece I needed support on was the inner bracket where I used the custom supports plug-in for Cura


###Fitting Instructions
- Insert the M5 flat nut into the slot on the inner bracket, ensuring it lines up with the hole in the bracket.
- Insert the M6 nut into the end of the inner bracket, you may need a drop of glue to hold it in place depending on the nut profile.
- Secure the outer cup to your wall with th