Thingiverse
Tower mini trunking internal and external corner
door TommyUK
6
Downloads
7
Likes
0
Makes
OK, this is slightly different.
Tower trunking is designed to be used with the box attached to the wall and the cap side facing out. Despite appearances, the assembled trunking is not perfectly rectangular, and the "proper" fittings are made with this in mind.
On a recent installation, I had reason to use the trunking in reverse - the proprietary fittings are too small in that configuration.
So I made these.
Lay the external corner one flat surface on the slicer bed and there's no need for support.
The Internal corner does need support, though.
Tower trunking is designed to be used with the box attached to the wall and the cap side facing out. Despite appearances, the assembled trunking is not perfectly rectangular, and the "proper" fittings are made with this in mind.
On a recent installation, I had reason to use the trunking in reverse - the proprietary fittings are too small in that configuration.
So I made these.
Lay the external corner one flat surface on the slicer bed and there's no need for support.
The Internal corner does need support, though.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!