Toy dump truck

When printing the "Tiny Toy Dump Truck" on my Solidoodle3 I ran into precision problems, i.e. axles getting stuck and breaking. Thus I recreated the toy truck with bigger tolerances and push-fit axles.

You need to print both the toyDump.stl and toyWheels.stl files (if you are using Repetier software just load both prior to slicing them for a single print).

Make sure to turn off supports in your slicer. You might want to enable solid layers for small areas to make sure that all axles are solids. 0.3mm or 0.1mm layer height should both work.