MakerWorld
Electronics
Go to Model
TP-link EAP 6 series vertical stand
210
Downloads
31
Likes
128
Makes
I was inspired by a similar model, but I wanted mine to be more rounded, lower, and with smaller front armsβso I designed my own stand from scratch. Finished off with a colorful Omada logo on the back, just for that extra bit of swagger. π Printed with PETG from Devil Design (white + dark grey). This material can handle flow rates over 20 mmΒ³/s, so the print time is around 1.5 hours. For compatibility, the published model is set to Generic PETG. The rear mounting holes are spaced 50 mm apart, with a 4 mm diameter. If your access point came with the same mounting plate as mine, use the "A" holes. The top section includes a 3 mm recess to help reduce heat transfer from the metal mounting plate to the printed model.
PedroKV also publishes on
35 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet β be the first!