MakerWorld
Electronics
Go to Model
TP-Link Tapo C100 Base (extension)
276
Downloads
62
Likes
193
Makes
Wanted a base for the TP-Link Tapo C100 camera to use with the BambuLabs A1. I started with the typical adapter that attaches to the A1 screen and though it works fine I wanted an alternative that did not add weight to the screen. In doing so I found the simple stand (original source: https://makerworld.com/en/models/856556) and lengthened the neck so the camera sat approximately at the same height as the adapter that uses the A1 screen. I also reduced the head (ball joint) of the adapter to roughly 99% on the XY directions to give it a tighter grip of the camera. Printed in Atomic PLA though PETG is probably best for these type of joints.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!