Thingiverse
TP4056 Button Cell Charger Module
by Michaelo
3
Downloads
5
Likes
0
Makes
***Button Cell Charger***
A simple button cell charger consisting of a TP4056 Module, some Nickel Plated Strip and a 3d printed housing (optional extra 3d surround to cover wiring)...
Charging Lithium-Ion Button Cells should be current limited to 20mA or lower. In this project you need to replaced the current limit resistor with a 56k ohms on the TP4056, to provide 20mA charging... Total cost under 1$
Nickle strip 0.15mm x 10 Meters can be fount on AliExpress for about €3.50. The TP4056 costs ~ 30 cents...
Push the nickle strip through the slits, wrap and solder on bottom join (one for + and -)...
Solder wire to + and - terminals of the PCB and connect to corresponding nickle strip...
Print time ~ 20 minutes for the main housing, no supports required...
A version for the USB-C TP4056 is included, the board costs ~ 80 cents...
The low cost 30¢ version of the TP4056 is ideal for charging only, it does not provide over-discharge protection, use the USB-C type board
A simple button cell charger consisting of a TP4056 Module, some Nickel Plated Strip and a 3d printed housing (optional extra 3d surround to cover wiring)...
Charging Lithium-Ion Button Cells should be current limited to 20mA or lower. In this project you need to replaced the current limit resistor with a 56k ohms on the TP4056, to provide 20mA charging... Total cost under 1$
Nickle strip 0.15mm x 10 Meters can be fount on AliExpress for about €3.50. The TP4056 costs ~ 30 cents...
Push the nickle strip through the slits, wrap and solder on bottom join (one for + and -)...
Solder wire to + and - terminals of the PCB and connect to corresponding nickle strip...
Print time ~ 20 minutes for the main housing, no supports required...
A version for the USB-C TP4056 is included, the board costs ~ 80 cents...
The low cost 30¢ version of the TP4056 is ideal for charging only, it does not provide over-discharge protection, use the USB-C type board
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!