MakerWorld
Test Models
Model downloaden
TPU calibration cube
107
Downloads
8
Likes
38
Makes
Hi all, lately I have been trying to print some models in BBL TPU 95A HF on my A1 printer and consistantly ran into several problems:walls not sticking togethersagging filament loops on the edgescrooked edges / wallspillingspotty wallsetc. …To get around these problems, I created a TPU calibration cube and after A LOT of experimenting, I found some decent settings which allow me to achieve consistently good quality in my prints at the cost of long printing times.Please note that the filament MUST be dried - if possible below 20% RH! For me prints with an RH value >30% have always failed, so I printed directly from my dryer through a short piece of PTFE tube.In this model download you find:an STL of the cubethe 3MF with the cube, the slicing profile and a slightly changed filament profileFeel free to experiment with infill, wall count and speed - I believe it is possible to optimize save some time :)Take a photo and comment your prints here.Your feedback will be appreciated and may help
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!