Thingiverse
TPU Wallet
von zachlothe
169
Downloads
292
Likes
1
Makes
Why spend $50+ on a wallet when you can spend ~$500 on a 3D printer and make your own?!
This wallet can hold up to 9-10 cards but I found it works best with 7.
Both card slots on the left and the top/bottom slot on the right are designed to hold only one card (for easy removal). The other two slots will hold 2 cards.
If the cards are a tight fit either cycle the cards in and out a couple times or print it again scaled up 1-2%.
Designed using Solidworks, file included.
This wallet can hold up to 9-10 cards but I found it works best with 7.
Both card slots on the left and the top/bottom slot on the right are designed to hold only one card (for easy removal). The other two slots will hold 2 cards.
If the cards are a tight fit either cycle the cards in and out a couple times or print it again scaled up 1-2%.
Designed using Solidworks, file included.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
