Trackball Tippler

This trackball tippler tilts thumb-operated trackballs by 45 degrees, resulting in much improved ergonomy as you do not need to twist your forearm.

It fits the Renkforce RF-WM-501, Renkforce RF-4760558 and physically comparable trackballs found on Aliexpress, Ebay and elsewhere.

You may either put the trackball loosely on the tippler or glue it to the tippler e.g. by double-sided tape. Access to the trackball's on/off switch and its USB wireless adapter receptable is possible through the tippler's backside cutout (see picture).

Supports required (see picture).

As always I include the OpenSCAD source file for you to adapt and/or improve:
- Download and install OpenSCAD from https://www.openscad.org
- Launch OpenSCAD and open the enclosed OpenSCAD source file (/File/Open).
- Amend the parameters at the top of the file or even amend the code.
- Save your changes (/File/Save).
- Render the design (/Design/Render).
- Export the rendered design e.g. as a .stl file (/File/Export/Export