Thingiverse
Tracked Inspection Bot (TPU)
von CammServices
334
Downloads
212
Likes
1
Makes
Great Micro Go anywhere tank with tilting FPV camera. I will be adding more options as time goes on, but I wanted to get these files live so people can start printing. I will be posting a build video shortly. This is a TPU/TPE (Semi Flex) print material only design. Turn Off Support material for all parts, you shouldn't need it.
When you finish printing the track give them a bit of stretching to soften them up a bit. They should fit with a bit of slack above the wheels. The Drive wheels are cogged and will move the tracks along just fine.
Battery Bay Dimensions Are:
32mm Wide
10mm Tall
65mm Long
The design will flex to accommodate if sections of the battery are larger. One of the reasons I chose TPU for the material.
Parts List
2x HexTronik MG14 Digital Metal Gear Servos (Modding Information Available Below)
1x Turnigy D56LV Digital Metal Gear Servo
1x Eachine TX03 3-in-1 FPV Camera
1x 3amp Micro UBEC
2 Cell Battery Pack (Recommend: Tattu 650mah for easy 4 hours of dr
When you finish printing the track give them a bit of stretching to soften them up a bit. They should fit with a bit of slack above the wheels. The Drive wheels are cogged and will move the tracks along just fine.
Battery Bay Dimensions Are:
32mm Wide
10mm Tall
65mm Long
The design will flex to accommodate if sections of the battery are larger. One of the reasons I chose TPU for the material.
Parts List
2x HexTronik MG14 Digital Metal Gear Servos (Modding Information Available Below)
1x Turnigy D56LV Digital Metal Gear Servo
1x Eachine TX03 3-in-1 FPV Camera
1x 3amp Micro UBEC
2 Cell Battery Pack (Recommend: Tattu 650mah for easy 4 hours of dr
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
