Thingiverse
Tracking pole repair
door DIYhans
5
Downloads
6
Likes
0
Makes
My tracking pole was broken in the middle at the locking mechanism.
Because this part was made from plastic I decided to make a copy of it.
The thread is M10 and inside diameter of the pole must be 15mm (outside 16mm)
Note:
The part must be printed horizontal for its strength.
For horizontal printing you need supports.
I have not tested a print in vertical position.
Because this part was made from plastic I decided to make a copy of it.
The thread is M10 and inside diameter of the pole must be 15mm (outside 16mm)
Note:
The part must be printed horizontal for its strength.
For horizontal printing you need supports.
I have not tested a print in vertical position.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
