Tradfri Remote Holder
door Ro_Yo_Mi
12
Downloads
7
Likes
0
Makes
When mounting the Tradfri remote on a wall, the included magnetic base is horrible. I found that the slightest bump or sideways brush would send it falling to the floor where it'd roll into some out of sight corner.
Included here are two models. One has a retaining bump that holds the remote in place and the other doesn't.
The back is completely flat.
No magnets are required for this.
I mounted these where needed using VHB tape. I'm not affiliated with Jimmy DiResta in any way. Here is a video showing some cool things you can do with this tape: https://www.youtube.com/watch?v=RxYJ5fDmwjY
I printed my with PLA, using 0.15mm height, and 5% infill.
Included here are two models. One has a retaining bump that holds the remote in place and the other doesn't.
The back is completely flat.
No magnets are required for this.
I mounted these where needed using VHB tape. I'm not affiliated with Jimmy DiResta in any way. Here is a video showing some cool things you can do with this tape: https://www.youtube.com/watch?v=RxYJ5fDmwjY
I printed my with PLA, using 0.15mm height, and 5% infill.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
